Here is Cortana fan art figurine, this awesome model took me quite a while to finish hopefully you guys love it as much as I do, the model comes pre-painted in bambu studio and comes in multi part for easy printing or painting. The model includes cortana head, chest, arms, left leg and right leg, and the ai chip as a base. To assemble the model slide the arms in from the back until they sit flush to the back, the head and legs should slide in if there a little tight then make sure to clean the inside of the holes, I also recommend using a small amount of glue to set the parts in, after testing if they fit. once the Body legs, arms and head are set I recommend installing the figure into the base using a small amount of glue again. If your printing the multi colour it will take 26 hours at 100ms, for the cortana parts and 2 hours 30 minute's for the base, If your not printing with mutli colour it should take 10 hours at 100ms, at full size, Print settings, Nozzle size 0.4mm, Layer height 0.2mm, Supports needed for everything but the base, Support type normal or tree, Support overhang angle 50% or for bambu studio 31%, Infill 20%, Infill pattern grid, Wall count 3, Print speed 100ms,