Master Sword Test Print
2K downloads · 5 years ago · This is the test print for the collapsing Master sword. Its 24mm high so what I do is change retr
This model is restricted by licensing terms.
View license.
This is the test print for the collapsing Master sword. Its 24mm high so what I do is change retraction setting every 8mm. Then I compare the changes until I achieve the best result. Each printer is going to be different but in my case for this blade I used a negative “extra restart” distance to reduce the size of the layer seam.
If the three pieces are completely separate you should have a successful print.
Master Sword Test Print
2K downloads · 5 years ago in and
This model is restricted by licensing terms.
View license.
BYOK #10
Fallout Access Granted Illuminated Panel
The Incinerator Multi-Color
The Incinerator Collapsing Lightsaber
Fallout Access Granted Panel
Devon Izara's Collapsing Lightsaber
Sakonji Tomioka Katana
Master Sword Vertical Wall Mount
Collapsing Easter Basket
Buster Sword Wall Mount
Textured Planetary Egg Container
Ezra Bridger 3rd Collapsing Lightsaber
Illuminated Galaxy Edge Control Panel #2
Illuminated Galaxy Edge Control Panel #1
Illuminated Mini Lightsaber
Galaxy Edge Control Panel #2
Galaxy Edge Control Panel #1
Gear Pot
Galaxy Edge Themed Switch Plate Covers
I’m new to printing. What do you mean “every 8mm” I’m using orca slicer.
I tried printing this and it seemed to fuse at the seams.
You dont have to change setting at that height, I just did so each test print I could try 3 different setting. I'm not sure if you can do this in Orca Slicer. You could always just stop the print after 8-12mm to see the results.