Spool Size Silica Gel Container

can_silica_container.stl

AMS Dryer V2 - Duct.stl

PolyMaker PolyDry Reverse Bowden Retainer

PolyDry_Reverse_Bowden_Retainer_V2.step

AMS Dryer - Duct-3.stl

filament storage dry box

drybox attachments v3_PLA_59m3s.3mf

Bowden Tube Holder for K1

This is a press fit bowden tube holder for the Creality K1. If you connect a dry box or just want to guide the filament using a bowden tube, this will hold the tube in place.

Tolerances are important for it to press fit into the honeycomb.

Note - Print it vertical for maximum strength. No supports needed for printing but if you feel just add a brim for adhesion.

PC4-M6 Threaded Cap

I wanted to build a dry box but spend less time printing the interfaces... One of the solutions I put together was to use a PC4-M6 attached to a small section of TPFE tube and this cap to seal the end. Of course this is a waste of a PC4-M6 and so a temporary solution if you have a proper bowden setup. But if like me, you had these to spare, it does work a charm until I decide on/design/print a better solution.

desiccant box round

body

AMS Dryer V2 - Adapter.stl

No-Drill, Print From, 100% Dry Box Mod

Spool Mount V2.stl

25 to 40 expansion

This is another model I put together while building up a solution similar to https://www.printables.com/model/146367. I was not able to find the 40mm pipe required and so needed to make a 25mm pipe that I had on hand, fit without the spools losing height in the box.

The half moon shape, when sitting with the opening upward, allows a 25mm pipe to side in a harness designed for a 40mm diameter pipe, while still meeting the same highest point.

Printing 2 at the same time:
- Layer height: 0.2mm
- Infill density: 10%
- Print time: 0h41m
- Total filament used: 3.035m

Plastic House Dry Box Mount

Dry Box Holder.stl

Dry Box

Trending this Week

Categories

Trending

Trending

Popular

Paid

Videos

New Uploads

Downloads

Trending

Popular

Paid

Videos

New Uploads

Downloads

Spool Size Silica Gel Container

AMS Dryer V2 - Duct.stl

PolyMaker PolyDry Reverse Bowden Retainer

AMS Dryer - Duct-3.stl

filament storage dry box

Bowden Tube Holder for K1

PC4-M6 Threaded Cap

desiccant box round

AMS Dryer V2 - Adapter.stl

No-Drill, Print From, 100% Dry Box Mod

25 to 40 expansion

Plastic House Dry Box Mount