Introducing the world's greatest cable clip (ok, maybe not the world's greatest, but definitely great, because it works!!)

This was designed to be strong and do its job while having some stylish flare. It was meant for thicker 10mm cables that I had which were causing me some grief.

This will take standard panel nails that are at least 25mm (1") in length. The cable cord clip has little tabs that will hold the cord in place so the wire doesn't come out of the clip. This makes it easier to hammer into the wall.

This prevents my daughter from pulling on the cable and perhaps causing a bigger issue. Out of sight, out of mind!

Designed in Fusion 360 with strength in mind. Each of these will print on my Prusa i3 MK3s+ in about 11 minutes at 0.20 layer height. Faster still usable prints can be had at 0.30 layer heights. You will save a few minutes.

Very easy to install, just slide your cable cord in the slot add a nail bang it in the wall and now your cords are neatly mounted to the wall. The best part of printing this yourself is that you can choose a filament color that matches your wall!