Give your IKEA VAPPEBY Gen3 Speaker a full glow-up with this cool retro VOXEL Kit. This download includes the pictured Cover, Studio Volume Dial, and Square Handle. (The power button can be downloaded seperately here)

Printing Guidelines

Handle:

• 0.16 mm layer height
• 4+ walls, 15%+ infill (use your discretion to make a strong part depending on the filament you use)
• No supports required

Volume Dial and Cover:

• 0.16mm layer height
• 2 walls, 15% infill
• No supports required
• For the Studio Dial, start with an opaque filament, and swap to a transparent filament above 8mm (at Z height 11mm if you want it to line up with the cover)

Assembly

Handle:

• Use the original screws for the stock VAPPEBY handle to connect this part
• Do not overtighten the 3D printed screw. That will cause the layers to be ripped apart.
• You can optionally add the 'Handle Spacer' between the handle arm and handle if the square screws do not line up well when tightened (this varies based on printer bed leveling, dimensional accuracy, etc.)

Cover:

• Print four of the cover pins. Connect them to the back corners of the cover with a 1/4 twist clockwise (You can use pliers if the fit is tight).
• Cover should press fit into the existing rubber holes on the speaker.

Studio Dial:

• Optionally print the 'Studio Dial_Indicator' in another color and glue it into the divot on the Dial for an orbiting indicator (the orange dot shown in the photos).

Feel free to leave a comment if you have any questions!

Filaments Used in Photos:

• Panchroma Neon Green PLA (Amazon)
• Panchroma Neon Orange PLA (Amazon)
• Panchroma Matte Charcoal Black PLA (Amazon)
• 3DJake ecoPLA Tough (out of stock)

Printer Used:

• Qidi Plus4 3D Printer (Also on Amazon)

These affiliate links give me a commission on sales at no additional cost to you. Thanks for supporting Make Anything!.