Desk Edge Cable Holder (Print upright, no supports)
3.8K downloads · 2 years ago · Make sure you print this upright!
A solution to keep your cables on the edge of your desk for easy
Make sure you print this upright!
A solution to keep your cables on the edge of your desk for easy access while also being able to easily swap them around.
The revolving chamber has gooves for your fingernail to make it easier to spin. The first few spins will take a little force until the layer lines detach and smooth out.
It's designed to grab onto the end of any cable and hold it at an angle above your desk surface so you can easily grab and pull on it.
Desk Edge Cable Holder (Print upright, no supports)
3.8K downloads · 2 years ago in  andÂ
(V2) For BIQU B1 - DIY Enclosure - Remix of Prusa's V2 IKEA Lack Enclosure - with extra doors (opening on 3 sides)
Desk Cable Holder
Desk Cable Organizer Hook – 3D Print STL – Headphone Holder – Modern Cable Management – Minimalist
Complete Desk Cable Management - 6-Model STL Bundle for 3D Printing
Desk Cable Tower Organizer
Desk Cable Hook
Desk Cable Management Holder
Yootech Charger for Desk Edge
Desk Cable Organizer Set – Single, 3x & 7x Slot
Desk Cable Grommet – Ø35 mm inner Ø50 mm flange.STL
Cable Organizer Under Desk - Divided Clip
Guitar Rest for Desk Edge
Under Desk Instrument Cable Extension
Simple cable management for desk
Cable Organizer for table edge
Under-desk cable tray
Bundle
Orbit 8 | Under-Desk Minimalist Cable Management Organizer (8-Slot)
Phone & Pen Desk Stand with Cable Slot
Cable desk grommet 60mm
Version without screw holes for mounting/VHB tape would be nice.
Good print, what brand of filament did you use
A version for Ikea Skadis please
is it possible to make one with 10mm spacing or make a fusion 360 file so it can be customized for personal use?
Awesome project! printed a bunch to gift my wife and friends, thanks for sharing!
You know it'd be cool if there was a version of this with some neodymium magnets inlaid into it so that it could attach to a metal desk 😃
just use 2-sided tape. clean with alcohol first.
Hi, love this design... Can this also be printed with more infill?
absolutely
One of my favorite print-in-place models. I printed one which worked perfectly for my desk, and then proceeded to bring 5 more. Love this design!
I had to losen the collars with a slight hit with the back of a screwdriver.