If all you want is a bolt that can be thumb tightened, here is a way to get there. The M4 bolt I used has a hex head with measurement of about 7mm across (flat-to-flat) and a depth of 3mm. My thumb screw part sits around the bolt head which can be secured with a suitable glue, eg. CA glue, Epoxy resin.
My print is made in 1.75mm eSUN PLA+ filament, with 0.2mm layer height and 15% infill on a Bambu X1 Carbon printer. Print supports are not required.
I hope that you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
For more of my models, see my main uploads site: https://makerworld.com/en/u/3687936443
Categories:
3 Likes8 DownloadsMarch 23, 2024
3 Likes8 DownloadsMarch 23, 2024