This is a very simple case for the wren keyboard. Basically it is a box with cut-outs for the connectors.
It improves the sound though an gives some protection.
To assemble I removed the bottom plate from the keyboard and screwed it to the case with the M2 / 8 screws that are use for building the keyboard.
Printed in rPLA by Recycling Fabrik Supports for the cutouts (might not be necessary) 0,2 layer heightYou can find the keyboard here: https://github.com/oliviahanley/wren-keyboard. I only designed the case.
0 Likes0 DownloadsOctober 31, 2024
0 Likes0 DownloadsOctober 31, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density20 %
SupportsGrid