This is a simple mount for attaching a small tabletop to the reclining Hbada E3 chair, allowing it to be converted into a convenient workspace. This is my implementation of an idea inspired by the video: https://youtu.be/CCTRWARIBDs.
Note that the longer edge in the print may tend to warp. Using brim, reducing cooling or a closed print area should help.
I made the top from 6mm plywood - that's enough to support a light laptop, but for something more, a thicker one would be better. The dimensions of the plywood I used are 70x38 cm. This width is enough for assembly with narrowly set armrests. The laptop is held on a thin rope.
Category:
0 Likes1 DownloadsNovember 14, 2024
0 Likes1 DownloadsNovember 14, 2024
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
SupportsNone
BrimYes