Used to hold an airtag centered axially in a drill to apply a brushed finish to the stainless steel battery cap. This finish wears much nicer than the polished& etched original surface, and is easy to touch up if desired. 80 grit sandpaper worked great for my liking, but adjust depending on your personal preference.
The second part is used as an ejector to remove the airtag by pressing on the back side without marring the plastic face of the airtag. You may be able to use a hex key or similar if you don't mind marring the plastic of the airtag. This is version 0.2, works well enough but could use some tweaking that I may or may not get around to.
Filament used: Polymaker Polyterra PLA matte blue
2 Likes5 DownloadsApril 27, 2022
2 Likes5 DownloadsApril 27, 2022