Eibos Easdry Replacement Door Finger Pull

The paracord finger pull on the door of my Eibos Easdry filament dryer broke pretty quickly, which made it really frustrating to open the door. I made this replacement finger pull that can be used instead. Note that the door on my unit is a very snug fit, so the spring latch is unnecessary. If your door does not fit snug, this part may not work for you.

To install, remove the door and pull the two halves apart. Start at two corners and then the rest should pull away fairly easily. Remove the latch and spring and put the printed part in as shown in the attached images. Snap the halves back together and you're good to go. Naturally, this should be printed in a filament that can handle heat. I'd recommend PETG at a minimum.