Pegs: This peg is used to connect different modules together. I recommend printing a bunch of these and just setting them to the side and using as needed.
Hardware needed: None
Instructions for Printing: Raft = no Brim = optional but not needed Wall Loops/Top and Bottom shells = 2 - 4 (personally i like 4 for extra stability) Layer Height = 0.2 mm Speed = Default Temperature = Default for your material of choice Orientation = One of the flat sides. This makes it so there is less resistance when inserting and makes it so if things do get stuck, the sheer point will happen on the peg instead of the module.
During testing I used the Bambu Labs x1 Carbon with PolyLight PLA and left most settings in the Bambu Studio as default with any changes listed above so your print times may vary.
Material = roughly 3 grams Time = 23 minutes Material and time includes the Bambu X1 Carbon prep time and flow lines.
I recommend printing a full build plate worth, for me I print about 50 at a time and put them in a bag for later use. I have added this as an optional file.
Peg X 50: Material = roughly 88 grams Time = 3 hours 20 minutes Material and time includes the Bambu X1 Carbon prep time and flow lines.