End Connectors: These are used to connect the modules on the ends for added stability. I have added connectors for the front and back ranging from 2 - 4 module units.

Instructions for Printing: Raft = no Brim = optional but not needed Wall Loops/Top and Bottom shells = 2 - 4 (personally i like 4 for extra stability) Layer Height = 0.2 mm Speed = Default Temperature = Default for your material of choice

During testing I used the Bambu Labs x1 Carbon with PolyLight PLA and left most settings in the Bambu Studio as default with any changes listed above so your print times may vary.

3 hole slots: Material = roughly 37 grams Time = 1 hour 10 minutes Material and time includes the Bambu X1 Carbon prep time and flow lines