If you enjoyed slider maze level 1 and level 2, then the batch of levels 1 to level 5 is what you must get. Each level is more difficult than the previous one. And while it’s a quick print, you will have plenty of fun until you actually manage to solve them all - remember that no tile can be left alone, all the paths must be connected!
Each maze consists of 24 times and 1 empty space so that you could move the tiles around. This is a print in place design that requires no supports, however, It might require a little wiggle for the tiles to come separate after the print (based on the print settings).
If you want to test it out, you can get level 2 for a limited time for free here: https://than.gs/m/1101874
Can you solve them all? It’s not as simple as you would think! But if you are up for a challenge then print this rather quick print in place slider maze and enjoy!
Printing specifications:
Each slider maze:
Print Dimensions: base of the Slider maze is 14.2 cm ( 5.6 inches) by 14.2 cm (5.6 inches), height of this part is 0.7 cm (0.28 inches) Layer height: 0.2 mm Infill type: Gyroid Infill percentage: 12% Print speed: 250 mm/s Print time: around 3 hours Amount of material required: around 28 m (83 grams)