Order summary

Devin B
Make Anything“Make Anything Merc...” plan
$270.00$360.00

Annual payment$360.00
Sales taxEnter address for total


Total due todayEnter address for total

Powered by

Payment details

PayPal
Card
Enter address to calculate annual payment.
By confirming your subscription, you allow Thangs to charge your card for this payment and future payments in accordance with their terms. You can always cancel your subscription.
Devin B
Make Anything12K followers
Make Anything
Make Anything
|
Image 1 of 5
Tautochrone Track 3d model
Make Anything
Make Anything
|
Image 1 of 5
Tautochrone Track 3d model
Tautochrone Track 3d model
Tautochrone Track 3d model
Tautochrone Track 3d model
Tautochrone Track 3d model
Tautochrone Track 3d model

Tautochrone Track

This model is restricted by licensing terms. 

This desktop experiment tests the principle of a cycloid track, where no matter where you place a ball on the track, it should reach the bottom in the same amount of time. Impossible? Apparently not!

Requires 12 6mm x 3mm disc magnets, and 2 springs out of a pilot G2 pen (buy a 12 pack and you can swap the cartridges to not waste pens). Of course you also need steel balls. The exact size can vary, but these 5mm steel bearing balls are affordable and should work well.

See the process video for assembly and demo


Discussions

Tautochrone Track

32 downloads · 3 years ago in  and 
Devin B
Make Anything12K followers
This model is restricted by licensing terms.