One twist to seal your snack bags.
That's all it takes with this PENTACLIP.
Magnets on one side, to store your clips on your fridge door or rangehood.
One side of the slit has an opening width of 8mm, so you can slide the clip on top of your bag with ease.
Give it a twist and the 3.5mm slit will keep you bags tightly sealed.
2 files available:
one with holes for 10mm magnets
(the hole depth is 2.5mm, so you can use magnet thickness from 2 to 3mm)
one version without magnet holes, if you're just planning on keeping them in a drawer.
Happy printing!
DIMENSIONS | W 72 mm x L 72 mm x D 17.5 mm
3D PRINT SETTINGS
All STL files are already oriented properly.
The clips print upright.
No supports or brim needed.
Resolution: 0.3mm/layer or less
Wall line count: 2
Infill: 20%
Build adhesion type: None
Supports: None
