Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:5474699.

COFFEE DISPENSER

Watch the video: https://youtu.be/BWoMwAzL7AI

Just put your coffee pot (or mug) under the dispenser and turn the knob 180 degrees and a standard portion of coffee is dispensed into your pot.  Pour some hot water and enjoy your coffee.

STL FILES: There are 9 thing files of which 4 of them are optional:

1. The Dispenser
2. Cylinder Spoon (12cc)
3. Cylinder Spoon (24cc)_ Optional
4. The cylinder spoon "Lock Cap"
5. The wall mount Cradel
6. The coffee Container_ Optional(*) 
7. The Funnel_ Optional
8. Cylinder Spoon (5cc)_ Optional (upon request)
9. (NEW!) Sugar Container_Optional(**)

(*) The Container is optional as you can twist any standard/universal PET bottle onto the dispenser. (**) Thanks to @DjiZon who inspired me to make this additional container for those who want to use the dispenser for sugar instead of coffee.

MOUNTING AND USIN INSTRUCTIONS: While mounting the Dispenser you can insert either the 5cc, 12cc or the 24cc Cylinder Spoon as desired.

After inserting the desired Cylinder Spoon in the dispenser lock the cylinder inside the Dispenser with the "Lock Cap".  Push hard and click.

Mount the Cradel to any vertical surface (preferably to a wooden surface) with 4 small screws and slip the Dispenser from the open top side.

Use the optional Funnel to fill up the Container (or a dry PET bottle) with coffee .

First twist close the Container with the Dispenser and then turn it upside down before slipping the Dispenser (from the top open side) to the wall mount Cradel .

To change the Cylinder Spoon with another one, force pull the "Lock Cap" until it's relased and change the Cylinder Spoon and then lock it again as before.

OTHER NOTES: Suitable for grain/granular coffees; as powder coffees stick to each other and jam the container neck (at least the portion dispensed would not be standard).

Keep the Dispenser away from moisture to avoid sticking and jams in due course.

Health Warning: PLA is non-toxic but may keep bacteria in the long term. Please check 3d print material's health issues before use.

PRINTING INSTRUCTIONS: Filament: PLA Layer Height: 0.28mm Infill: 15% Supports: NONE Build Plate Adhesion: NONE

Happy printins...:)