This is a remix of Jmperou's original (https://www.thingiverse.com/thing:5380573) design the only thing I altered was the screw hole circumferences so that I do not have to use threaded inserts. All of the sizes were adjusted to accept the original hardware that comes with the Anycubic Kobra Max. I have tested this on my printer and have not had any issues. I printed this remix in PLA without issues any material will work. Major props to Jmperou for an amazing file, it is an amazing replacement to the original housing. Especially if you snap the original housing like I did and can't find a replacement on Anycubic's site.

I printed at 0.2 resolution smaller resolutions will work not sure on bigger resolutions.