Ok there is a lot of things to say here:
1. This is a remix of the incredible gyroid shoes by DaveMakeStuff, so all credits to him. The opening was widened to allow the feet to get in and out. 2. THIS IS NOT AN EASY PRINT ! I made it as easy as possible but it was only tested on well tuned Bambu X1, do it at your own risk (and be sure to share to help others) 3. Use TPU, (personally used a 95A). 4. Use (slim) TREE SUPPORTS, the reason is that the model was raised to not get a flat sole and if your printer is well calibrated it's actually surprisingly easy to get off. (see pictures) 5. For the same reason, there is a small part under the shoe so it doesn't automatically lay flat on the bed,** IT'S A BIT FAR AWAY**, feel free to lower the shoe closer to the bed. 6. Its not perfect, the original design was no designed to be worn, and the sole is practically non-existent. 7. Fo an easier time I varied the scale for popular shoes sizes, I only wore the US8.5 EU42, so let me know if it works for you too.
With all of that said Its still an amazing shoe to wear, the design is beautiful and I would say that it feels pretty close to crocks. The pictures are of the shoes without the widened opening, I'm still waiting for a new TPU roll, but with similar design should come similar results, I'll update when done.