AnxiousMold2329

Fighting Tops

by
Anxious Mold
Follow
Follow
Remix Model
Anxious Mold
Anxious Mold
|
Image 2 of 5
Fighting Tops 3d model
Anxious Mold
Anxious Mold
|
Image 2 of 5
Fighting Tops 3d model
2D
3D
Makes
Fighting Tops 3d model
Fighting Tops 3d model
Fighting Tops 3d model
Fighting Tops 3d model
Fighting Tops 3d model

A Beyblade-like system of tops that you can have fight to the death (or until one stops spinning).

Assembly

  • print a top piece, bottom piece, launcher, and pull ring
  • push filament into the holes of one half of the top
  • cut the filament to leave 3 "prongs" sticking out of that piece
  • click the top half and bottom half together (you can use glue to permanently join)

-Tip: the spikier tops cause shorter, but more violent fights

  • tie 6-7 inches of dental floss to the pull ring

To Use the Top

  • insert the "stick" of the top through the holes of the launcher
  • turn launcher upside down (so that the top is on top of it)
  • insert ~.5 inch of floss into the hole of the top
  • spin the top to wrap the floss around the stick
  • pull the pull ring and watch your tops fight

6 Likes12 DownloadsJuly 4, 2024


6 Likes12 DownloadsJuly 4, 2024