2D3D
Makes
This model is restricted by licensing terms.
View license.
1 Likes11 DownloadsJanuary 23, 2022
This model is restricted by licensing terms.
View license.
This mini wire tie was part of an experiment to use raw filament in different ways.
After 1 year of using this design, I can now say that it's best to use scrap TPU instead of PLA for the raw filament.
PLA can work, but only in scenarios where the filament is bent into a very gentle radius. The results also probably depend on the exact PLA used - some formulations become so brittle that no amount of gentle handling will help.
Category:
1 Likes11 DownloadsJanuary 23, 2022
This model is restricted by licensing terms.
View license.
1 Likes11 DownloadsJanuary 23, 2022
This model is restricted by licensing terms.
View license.