The Googol Maze is a maze building system with an absurd number of layouts.

Printing

• For best results, the frames must be printed with absolutely no curling. If bed adhesion is an issue, add a brim.
• Swap colors half-way through printing walls and pegs so that the maze pops.
• Test print a loose wall and tight wall to determine which option will work best for your frame. The walls should be easy to insert and remove, but tight enough not to get knocked out by the ball bearing.
• If supported by your slicer, enable Arachne perimeters while printing the wall pieces.

Hardware

Maze is designed for 6mm ball bearings.

Quantities

Some wall pieces will be used more than others. straight “L” walls and corner “C” walls are used a lot. “X” walls are very rarely needed.

Can I sell copies of this?

Yes! This project was shared under the Creative Commons - Attribution license.

This license allows selling copies, but you must provide proper attribution, as detailed in the license itself.

Please note that any other projects linked here (remixes or related projects) may have a different license. Please respect those licenses.

This license applies only to the model files (STL, 3MF, STEP, F3D) included in this project. It does not apply to photos, videos, my logo, or other supplemental graphics attached to or displayed with this project.