A simple, minimalist tape dispenser designed for general-purpose double-sided and regular painting/plastic tapes.

Just orient the object flat on its back and start printing (without supports).

I recommend printing the object with the variable layer height setting enabled in PrusaSlicer to ensure the teeth are sharp. In some cases, it also helps to insert the tape with the sticky side up for easier dispensing.

Size: 6.7 x 6.7 x 3 cm Print time: 3 - 4 hours

Settings:

Layer height: 0.25 mm (with adaptive variable layer height enabled @ 100% quality) Perimeters: 2 - 3 Infill: 10% Top and bottom layers: 5

This is a fun/ experimental design. Any tips for improvement or feedback would be appreciated :)

Happy printing!