Jigsaw Vase 4 parts Voronoi

171 downloads · 4 years ago · A slot together 4 part Jigsaw Vase. This is a collaborative design with 3DPrintBunny. Print in vase

This model is restricted by licensing terms.

View license.

Description

A slot together 4 part Jigsaw Vase. This is a collaborative design with 3DPrintBunny. Print in vase mode. Download the Voronoi part (printed in mystic green) on this page and the plain Swoosh part (seen in black) here: https://social.thangs.com/m/65122

Tags:

Discussions

daniel.dugue624 years ago

en cura j'arrive a le trancher mais il manque des milliers triangles ; c'est inutilisable ca a de la gueule mais rien d'autre

Arkay_Prints4 years ago

Hi, thanks for sharing your concerns however I just want to reassure you that it is very much usable and has been printed several times with no issues whatsoever as you can see from the photos - I always test print my designs before uploading :) I do use PrusaSlicer though so perhaps this is a slicer specific issue?

Either way, I don't want anyone to struggle so I've just updated the model - you should find it doesn't have those errors any more, just to reassure you and anyone else who was put off by that!

Thanks again for highlighting the issue though.

daniel.dugue624 years ago

cela pourrait être intéressant ! ! !MAIS une ou des ERREURS sont bien présente et détectées(ssss) dans "Ideamaker" comme dans "Builder 3D" qui ne se réparent pas c'est regrettable j'ignore ce que cela va donner en tranchage