My goal was to make segments that can be connected end to end to cover nearly the entire table length (46cm), so these are 15cm segments. I can finally make my own table sleds with synthetic miter rails! I am sure this fits other saws with similar T-track-style miter rail guides, but I enginerded this for my own 10" table saw. Attaches to sled with standard flat-heat wood screws. There are two versions, one with "speed holes" and one without. (FWIW, the one without the speed holes prints slightly faster.) Modeled by myself. Example shown was printed on Elegoo Neptune 2S with Jessie PLA, sliced in Cura with .28mm settings, cubic infill, no supports needed. ~1 hour each. Please Like my post if you find it helpful! If you're so inclined, feel free to buy me a coffee.

Disclaimer: Use your prints at your own risk. There is no implied reliability or accuracy in this model, and I cannot accept liability in your choice to use it in your own design.