NODE - Basket Liner Retention Clip 01

A simple, purpose-built clip designed to keep fabric liners securely in place on woven or wire laundry baskets.

This was created to solve a common frustration—liners slipping, collapsing, or shifting during use—without resorting to bulky or over-aggressive clips. The geometry provides reliable retention while remaining easy to install and remove.

---

Features

• Purpose-built for basket liner retention (not a generic clip)
• Clean, low-profile form that doesn’t interfere with use
• Balanced flex for secure hold without excessive force
• Optimized for support-free printing
• Consistent performance with standard PLA or PETG

---

Fit & Use

• Designed for basket rims approximately 0.38" wide [10 mm]
• Works best with typical fabric liners (cotton/poly blends)
• Install by pressing over rim and fabric—no tools required

Note: Fit will vary depending on basket geometry and material thickness. Scale slightly if needed for your specific application.

---

Print Recommendations

• Orientation: Print flat as shown
• Layer height: 0.20 mm or 0.24 mm
• Walls: 3+ (4 gives you a solid infill and prints slightly faster, my recommendation)
• Infill: 10–15% (not critical). Honestly at this size, solid is perfectly fine.
• Material: PETG (suggested for durability) or PLA (general use)

No supports required.

---

Design Notes

This is a straightforward, utility-focused design—intended to solve a specific problem cleanly and reliably. No excess features, no unnecessary complexity.

---

Attribution

Part of the Engineered Modern (EM) collection Thoughtfully designed. Carefully crafted.