Mount for the BTT Eddy probe designed to attach to the right side of the Creality Sprite Pro extruder. This mount provides a rigid, low-profile installation with accurate probe positioning for Eddy-based bed leveling.

Mounting Hardware

• M3 8mm Socket Cap Screws (4)
• M3 nuts (2)

Two screws are for attaching the mount to the extruder. The other two are used with the nuts to attach the Eddy sensor to the mount.

Offsets for Klipper Configuration

• X offset: 29 mm
• Y offset: 0.50 mm

Print Settings

• Orientation: Print on its side
• Supports: Grid supports required
• Heat resistant material recommended

Important Notes

• The BTT Eddy must be used without its protective case for this mount.
• With the case removed, when following the official BTT calibration procedure, set the bottom of the Eddy to ~24 mm above the build plate (instead of 20 mm as stated in the standard documentation).