A Raspberry Pi Case for use with the GridFinity System.

The Case sits within a 1x2 GridFinity footprint by orienting the Pi vertically.

The top part of the case, where the USBs and Ethernet port exit, is attached via four (4) M2 x 8mm Bolts.

Four (4) M2.5 x 8mm(?) Standoffs should be used to secure the Pi to the case. In the photos: I have M2 bolts going through the Pi, a handful of washers ( ~6-8mm), through the case wall, then secured with nuts on the exterior. Due to not adding a recessed area for the nuts, it prevents a neighboring Unit from sitting flush/plumb/even. By using the appropriate standoffs, which will thread into the case without the need for nuts, it will hopefully look profesh.

Anyways, thanks for looking at my model and I hope it suits your uses! -X