**FLOAT Wall Vase - 3D Printed Edition ** Bring a touch of modern minimalism to your walls. This is the fully 3D printed version of the FLOAT vase, designed to hold a single stem or dried flowers. It attaches easily to the wall using magnets and a thumbtack, creating a "floating" appearance.

Two Design Variants Included: ・Type A (Ribbed): Features a textured surface with rounded vertical rods for a sophisticated look.

・Type B (Flat): A clean, simple flat surface.

Tip: In the photos, "Fuzzy Skin" setting was enabled in the slicer for Type B to create a textured matte finish.

Bill of Materials (Required Items): To complete this project, you will need:

・Test Tube: Outer Diameter φ15mm.

　* 🛒 Recommended Test Tube on Amazon

・Magnets: φ10mm x 2mm thickness.

　🛒 Recommended Magnets on Amazon

・Mounting: A standard thumbtack or screw for the wall.

Installation: The vase is held by a magnet. For extra stability (or if holding heavier items), there is a small safety hole designed for a thin pin or nail to lock it in place.

** Print Settings: ** A pre-configured .3mf file is included for easy setup.

Supports: REQUIRED (Yes)

Layer Height: 0.2mm

Nozzle: 0.4mm

Wall Line Count: 2 loops

Infill: 15% (Grid)

Material: PLA Matte recommended for the best aesthetic.

Filaments Used in Photos: All printed using Bambu Lab PLA Matte:

• Charcoal
• Ivory White
• Ash Grey
• Grass Green

Disclaimer: As an Amazon Associate, I earn from qualifying purchases via the links in this description.