This is a diy led lamp. use the same diy led lamp as the one for bambu labs. My daughter came up with the idea. i drew it in autocad for her then printed it. i used solid infill for the stem, partial infill for the flower and partial infill with 10 layers on the bottom for weight on the plant pot. this is a 9 yr old girls design so dont be to critical. she even said for the cable to be hidden through the back of the flower, through the stem and through the plant pot. To make this all go together i cut the wire off the led disc/puck then ran the wire through the plat pot, the stem then through the center hole in the flower. i unscrewed the disc. used a soldering gun to remove the old wires. stripped back the new wire, ran the wires through the center hole on the led disc and soldered them to the led disc. before i glued anything into place I did a dry fit and then i plugged the led light in to verify function. it worked so i glued all the pieces together. glued the wire in place. the led disc is a light friction fit so i didn't glue it. then i put the whole thing in the dehydration room to dry and fully cure, off gas ect.. i realize this isn't very practical, but it isn't for that . its so that a little girl can use her imagination to come up with an idea then see that idea come into reality and see every step of it . thank you for your time and have a great day.