Fans of the original Lego Technic system, show off your love for the building system with this 10x scaled standard bushing. It's not Duplo, just jumbo! The bushing is about 77mm long and 74mm around.

Model files include a single screw anchored snap on mount perfect for displaying your love for Lego on the wall where all can see.

A few minor liberties were taken with the geometry to make it printable without supports, but it's mostly dimensionally accurate at scale to the original.

• Print the bushing on its "X" end which shouldn't require supports. (The print shown had a accidental layer shift.)
• Print the mount top side down (the face with the thin plate). The screw hole peaks at a 45 degree angle for easy, no support printing.

And also see its friend the jumbo pin!