Case for the new, larger Nvidia Orin Nano Super Developer Kit SBC released in December 2024. This will not fit the older kits.

The case is two parts, the primary body of the case, and a backplate with holes for the ports. The carrier board slides into the case from the rear, and the backplate inserts from the top to hold everything in place. There are side slots for the GPIO pins and camera cables. Since the board slides out easily, just slide the board out to connect GPIO wires, then feed them through the slot when you reinsert the board. I'm not certain that the camera slot is useful as-is, but the FreeCAD files are included if you want to modify it.

The design includes back and bottom vents for better heat distribution. Additionally, it incorporates three channels at the front to direct airflow from the bottom of the case to the fan. Although the case requires feet for elevating, these are not included in the model. since I plan to use stick on rubber feet.

Designed to print with the front of the case on the build plate to minimize the amount of supports needed.