Remix of the needle file holder by noxi to accommodate 6 files instead of 5. Moved up the snap connector so that there is a bigger surface on the bed, should stick better. Slightly fixed some geometry issues.

I needed 6 slots for my needle file set so i made this.

Printed in PLA+, 0.2 layer height, 15% infill, 3 walls.

To install you also need a regular multiboard snap.

Rubber hammer helps getting it installed ;)

Update 20/07/2024: Added an alternative version that supports larger/thicker files up to 6mm thick. The default is 4mm.

Remix of: https://www.printables.com/model/816210-needle-file-holder-for-multiboard