This is Bully the Pitbull.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. This print is 233x233mm in size. You may print at higher layer heights below the Min Depth of 0.96mm. The Max Depth is 5mm and the Actual Depth is 5mm.

NOTE - MY RANGE OF PICTURE FRAMES ARE AVAILABLE SEPARATELY. SEE HERE

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA PolyTerra Charcoal Black Transmission Distance: 0.3 PLA BambuLab Basic Brown Transmission Distance: 2 PLA Overture Cement Gray Transmission Distance: 0.6 PLA BambuLab Basic Orange Transmission Distance: 5 PLA+ Esun Bone White Transmission Distance: 5 PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions: Start with Black At layer #20 (1.68mm) swap to Charcoal Black At layer #23 (1.92mm) swap to Brown At layer #25 (2.08mm) swap to Cement Gray At layer #27 (2.24mm) swap to Orange At layer #31 (2.56mm) swap to Bone White At layer #35 (2.88mm) swap to Jade White for the rest.

NOTE - Picture frame is not included in this download.