Zipper Pull - Low Poly Heart

Boring zippers no more! Expanding the Zipper Pull collection - a low poly piece. 💓

Items you need:

• 2 x “4mm x 30cm” paracord.
• *4 x “3mm (diameter) x 2mm (thick)” magnets (neodymium magnets are recommended for better holding power).

*If you do not have magnets, I have included a 3D-printed Connector.

Suggested print settings:

• Layer height 0.2mm.
• Infill 30%.
• Position the print in a way that the joining face is facing downwards.
• No supports are needed.
• Suggest using glossy filament for a beautiful reflective finish.

NOTE Most of our designs are printed and tested on a Prusa Mini and MK4, so tolerances may vary if you are using a different brand. While we strive for a smooth experience with our designs, we appreciate your understanding if tolerance issues arise.

This work is licensed under a Creative Commons (4.0 International License) Attribution—Noncommercial—Share Alike