This model is restricted by licensing terms.
View license.
MiSTer FPGA Case V2
Integrated DE-10, I/O Board and USB Board into single case. All sides of the case are printed flat to create clean surfaces.
I'm using M3x16 cap head screws on the top. These are the board layers and hardware in order from top to bottom: M3x16 cap screw IO Board M3x14mm male/female brass spacer DE-10 Nano Board M3x14mm male/female brass spacer USB board M3 nut or M3x8 female/female brass spacer to which I add the silicone covers the DE-10 came with.
UPDATE:
Added the Audio Port to the USB Side Wall. Added Side plates for USB v2.1, Side with larger SoG switch opening and Longer Buttons with more clearance. Light Pipes ID has been increased to Dia 5.6mm. Ensure your printer is tuned and not overextruding resulting in ID falling short. Optionally a 5.5mm drill can also be used to clean any extrusion start seams in the ID to better fit over the LEDUPDATE: 1/16/2022 - Added Digital I/O v1.2 Ports
Print Settings
Rafts: Doesn't Matter
Supports: Doesn't Matter
Resolution: .2
Notes:
Print in PLA
Category:
4 Likes52 DownloadsJanuary 19, 2022
4 Likes52 DownloadsJanuary 19, 2022
This model is restricted by licensing terms.
View license.