There are several variations and names for this game (e.g., Aggravation, Wahoo, Tock). This design is based on a board my grandfather made. My design allows you to fold the board up for easy storage. I've also created a generic game piece base so you can print any game piece tops you want and glue them on. All parts are designed to be printed without supports.

The board uses 101 5x3 mm disc magnets which can be found here: https://a.co/d/iZA7UWW

You'll need to print as follows: 1 x Cap 1 x Center Board 4 x Side Board 8 x Hinge Pin 16 x Game Piece Base

The game piece bases have a cavity for the magnets, so you will need to pause printing before the cavity is closed to allow you to add the magnets. Be very careful to verify your magnet poles are correct.