This is the base for a small table. The legs will stand approximately 6in off the ground, plus the height of whatever table top you use. Perfect for low-seated areas where you need a small table.
Prints in one piece, no supports. Includes holes to screw in a table top. I recommend the following settings:
15 - 20% infill 3 - 4 walls / perimeter shells 3 - 4 top & bottom shells
The more infill / shells you do, the better it will turn out. It will also use more filament, so you can choose your preferred settings. It will take between 10 and 15 hours to print.
Please note that this table is in no way meant to be load-bearing. This should go without saying but it's not a seat in any way, this is a base for a small table and has a load capacity of 5 - 10lbs. You're responsible for how you use it.