San G

Magnetic D20 Storage Box With A Tab

by
sanglover84
Follow
Follow
Remix Model
sanglover84
sanglover84
|
|
Image 5 of 13
Magnetic D20 Storage Box With A Tab - Needs to be cleaned up, have to fiddle with settings because of the huge temperature change (Canadian, it was 20C last week, it's -10C this week)
Used 7mmx2mm magnets, they fit snug but I still put in a drop of crazy glue - 3d model
sanglover84
sanglover84
|
|
Image 5 of 13
Magnetic D20 Storage Box With A Tab - Needs to be cleaned up, have to fiddle with settings because of the huge temperature change (Canadian, it was 20C last week, it's -10C this week)
Used 7mmx2mm magnets, they fit snug but I still put in a drop of crazy glue - 3d model
2D
3D
Makes
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab - Needs to be cleaned up, have to fiddle with settings because of the huge temperature change (Canadian, it was 20C last week, it's -10C this week)
Used 7mmx2mm magnets, they fit snug but I still put in a drop of crazy glue - 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab - Printed in place on a side, need to clean it up a bit. This filament is cool because it turns pink in the heat, or if you sit it by a sunny window. I used a brim. I just couldn't get it to print well with supports, so I printed in place and just clean up the numbered side. 

Used 10 7x2mm magnets, they fit snugly, used a drop of crazy glue I got 4 1mL packs for a dollar at the Dollar Store. Makes a satisfying "SNAP" when it closes. - 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab 3d model
Magnetic D20 Storage Box With A Tab - Same as before, printed on the face of a solid spot with a dice number. I can't get supports to work to get a good result. I use a heat gun on the side it was printed on to clean it up. 

The cold weather is really affecting my prints. - 3d model
Magnetic D20 Storage Box With A Tab 3d model

This is a simple D20 with a lid and in the main part it has a spot where you can store stuff, like dice, money, candy, and whatever else you can fit. It's 100mm at the largest point (while the top and bottom are connected) I added a tab to easily pull it apart.

I used 5 magnets on the top and bottom that are 7mm x 2mm basic magnets I bought on Amazon in a pack of 200 for $10 or so. I used superglue to glue them in, and they're a tight fit which is exactly what I wanted.

I printed this in place because I couldn't get it to print with supports. I rotated it so one face of one number on each part was in place.

If you have any recommendations on a better way to print this, let me know!


0 Likes3 DownloadsDecember 2, 2024



0 Likes3 DownloadsDecember 2, 2024

Instructions

Filament • 0.02mm

MaterialPLA
Layer height0.02 mm
Infill density10 %
SupportsNone
BrimYes