This Batman Gauntlet is split in two parts and designed to be held together with a strap, tie or cord. Any attachment method that fits through the slots will work but the Velcro straps I used were only £3 and can be found here https://www.amazon.co.uk/gp/product/B09KX6B27F/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1
Print Settings This design was produced so it could be printed on an ender 3 build volume.
I printed the parts upright but I would highly recommend a brim or raft just to prevent bed adhesion issues due to the height of the parts. Other than that, I used the standard low quality setting on Cura but with slightly increased speeds and reduced infill to reduce the print time and material.
Design Process I created this design in Fusion 360 from which I made a number of different variations until I produced this one. The parts were printed on an ender 3 and were designed with this in mind.
Sizing The Design was built to fit me, but I have included test files which will allow you to assess if it will fit and you can work out the appropriate scaling required to fit you.
When scaling, I would recommend adjusting the X, Y and Z scale separately.
Dimensions (mm) H:220 W:180 D: Arm ellipse: 100 by 85 Wrist ellipse: 69 by 54
Any feedback (positive or negative) would be greatly appreciated so please let me know what you think and don’t hesitate with any questions you might have. Thanks!