S

Batman Gauntlet

by
sandbag96
Follow
Follow
Remix Model
S
sandbag96
|
Image 1 of 9
Batman Gauntlet 3d model
S
sandbag96
|
Image 1 of 9
Batman Gauntlet 3d model
2D
3D
Makes
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model
Batman Gauntlet 3d model

This Batman Gauntlet is split in two parts and designed to be held together with a strap, tie or cord. Any attachment method that fits through the slots will work but the Velcro straps I used were only £3 and can be found here https://www.amazon.co.uk/gp/product/B09KX6B27F/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1

Print Settings This design was produced so it could be printed on an ender 3 build volume.

I printed the parts upright but I would highly recommend a brim or raft just to prevent bed adhesion issues due to the height of the parts. Other than that, I used the standard low quality setting on Cura but with slightly increased speeds and reduced infill to reduce the print time and material.

Design Process I created this design in Fusion 360 from which I made a number of different variations until I produced this one. The parts were printed on an ender 3 and were designed with this in mind.

Sizing The Design was built to fit me, but I have included test files which will allow you to assess if it will fit and you can work out the appropriate scaling required to fit you.

When scaling, I would recommend adjusting the X, Y and Z scale separately.

Dimensions (mm) H:220 W:180 D: Arm ellipse: 100 by 85 Wrist ellipse: 69 by 54

Any feedback (positive or negative) would be greatly appreciated so please let me know what you think and don’t hesitate with any questions you might have. Thanks!


69 Likes333 DownloadsFebruary 14, 2022


69 Likes333 DownloadsFebruary 14, 2022