2D3D
Makes
46 Likes122 DownloadsNovember 20, 2022
I designed this fully printable filament roll hanger to be strong, sturdy and to last.
It's designed with “no supports” ideology in mind, and as such prints easily with no supports,
Print the hooks laying flat for ultimate layer strenght. Pole prints standing with no supports.
Tolerances are tight, so screw and unscrew few times before using to loosen things up.
Pole and hooks have matching stoppers to stop the pole from turning.
Each side has three holes for screws, holes are 2mm in diameter, so use screws bigger than that and it will self tap.
Print set:
Hook: x2 Screw: x2 Pole: x1
Print with any material you want. Can be mounted in whatever orientation you want.
Category:
46 Likes122 DownloadsNovember 20, 2022
46 Likes122 DownloadsNovember 20, 2022