ATX PC CASE - 180 x 180mm print volume
27 downloads · 1 year ago · Total case size: **360 x 360 x 200mm.**
**PLEASE READ THE FULL INSTRUCTIONS BEFORE PRINTING!**
[Cli
Total case size: 360 x 360 x 200mm.
PLEASE READ THE FULL INSTRUCTIONS BEFORE PRINTING! Click here to see the full written instructions on Printables.
This case supports the following PC components:
- Normal ATX, mATX and ITX motherboards
- ATX PSU up to 140mm depth or SFX PSU.
- Graphics cards up to 335 millimeters. (Max 3-slot/61mm thick if using ATX PSU)
- Top mounted 120/240mm radiator or 2x 120mm exhaust fans.
- Front mounted 120/240/280mm radiator or 2x 120/140mm intake fans.
- Bottom mounted up to 2x 120/140mm intake fans.
- Up to 4x 3.5" Hard Drives or 6x 2.5" drives (At the cost of GPU length)
- CPU Air cooler up to 155mm tall
Parts required to build this case:
- M3 Threaded inserts (OD 4.6mm, length 5 or 6 mm)
- M3 x 10mm screws
- 8 x 3 mm Neodymium magnets
- 12 mm Power Button
- Glue for the magnets and butterfly joints (Use only a tiny amount of glue per part, avoid filling the holes too much)
ATX PC CASE - 180 x 180mm print volume
27 downloads · 1 year ago in and
Minimalistic vertical ITX case (v2.0)
Budget-friendly mATX case
Backpack-friendly ITX PC case v1.0
.png&w=3840&q=75)
Clean looking ITX PC case
Backpack-friendly PC case v2.0
Minimalistic ITX PC case for onboard graphics
12-bay ATX NAS case - 180mm print volume
NAS CASE 6-bay (+3 SSD) incl. STEP files.
PC case mini ITX, micro ATX & ATX design by Makeyo
ATX basic open pc case / test bench
.gif&w=3840&q=75)
Dart Blaster Helldivers 2 SG-225 Breaker Shotgun Prop Cosplay Replica Mechanical Toy DIY Rifle Pisto
.gif&w=3840&q=75)
Dart Blaster Helldivers 2 Talon Revolver Pistol Mechanical Replica
Paper towel holder
Mushroom shelf “Lentinula Edodes”
Mushroom shelf “Pleurotus Djamor”
Spaghetti bowl and meatball salt and pepper shaker
Planter “Extra”
Lamp “Bonbon”
Mushroom shelf “Trametes Hirsuta”
Hi, just finished all printing and when I was adding the motherboard and PSU, I realized my Corsair RM750x psu didn't fit there, it is a regular PSU, not a big deal. Is there a special printing to make it work? It's touching the magnet mount.