Toothbrush Cap

I was looking for a simple toothbrush cover for my son's toothbrush, but those I found were either far more engineered than we needed or too small. (Why this child sized toothbrush is wider than normal... who can say).
I did find something close to what I was looking for here https://www.thingiverse.com/thing:4615041 but it was a wireframe mesh and I don't know how to remix that, so I ended up designing one similar but with the differences I needed.

Extraction Pipe Window Holder

A fitting to fix my extraction pipe to my window, allowing me to:
- keep the window ajar for air
- blow air down so that it is less likely to come back in
- keep the window closed enough that the cats still can't get out
- print without needing internal support

25 to 40 expansion

This is another model I put together while building up a solution similar to https://www.printables.com/model/146367. I was not able to find the 40mm pipe required and so needed to make a 25mm pipe that I had on hand, fit without the spools losing height in the box.

The half moon shape, when sitting with the opening upward, allows a 25mm pipe to side in a harness designed for a 40mm diameter pipe, while still meeting the same highest point.

Printing 2 at the same time:
- Layer height: 0.2mm
- Infill density: 10%
- Print time: 0h41m
- Total filament used: 3.035m

Extraction Pipe Fitting

This is potentially quite specific to a Weedo M2 (and potentially Weedo F150) 3D printer. There is a fan which extracts ait from the enclosed printer through a filter, but I wanted to have more control of where the output went. I therefore put this convert together which wraps around  an 80cm fan outlet (and its filter cover which pushes the internal dimensions to 84cm) and then converts to a round threaded section to allow air conditioning piping or equivalent to be attached.

PC4-M6 Threaded Cap

I wanted to build a dry box but spend less time printing the interfaces... One of the solutions I put together was to use a PC4-M6 attached to a small section of TPFE tube and this cap to seal the end. Of course this is a waste of a PC4-M6 and so a temporary solution if you have a proper bowden setup. But if like me, you had these to spare, it does work a charm until I decide on/design/print a better solution.

I started 3D printing in August 2023... Needing to patch up an old printer off eBay I started my journey learning as much as possible! I am loving the challenge so far and I look forward to what I can do for my 3-year-old son as I gain experience as well as plan to share my creations as time goes on!

l33tch

Achievements

Seedling

Voyager

Novice Maker

Toothbrush Cap

Extraction Pipe Window Holder

25 to 40 expansion

Extraction Pipe Fitting

PC4-M6 Threaded Cap