l33tch
l33tch

Extraction Pipe Window Holder

by
l33tch
l33tch
Follow
l33tch
l33tch
|
Image 1 of 5
Extraction Pipe Window Holder 3d model
l33tch
l33tch
|
Image 1 of 5
Extraction Pipe Window Holder 3d model
2D
3D
Makes
Extraction Pipe Window Holder 3d model
Extraction Pipe Window Holder 3d model
Extraction Pipe Window Holder 3d model
Extraction Pipe Window Holder 3d model
Extraction Pipe Window Holder 3d model

Extraction Pipe Window Holder

A fitting to fix my extraction pipe to my window, allowing me to:

  • keep the window ajar for air
  • blow air down so that it is less likely to come back in
  • fit s good amount of filter material into the box
  • keep the window closed enough that the cats still can't get out
  • print without needing internal support

Note: Depending on your setup... I have since found out that the VOCs generated with good airflow actually increase rather than quickly reaching a saturation point. So try to seal your printer and have this solution to vent after prints rather than throughout.


0 Likes2 DownloadsSeptember 16, 2023