Now there can be a Tie between a Father in your life and #1 Dad. All #1 Dad's can be given this tie! This doesn't have to be just for Father's day, any Dad would appreciate this Tie in his collection!

This model is a two part print. It requires 3/8" snap fasteners (size 15) - https://a.co/d/9FlIdOR

I also use a UV curable resin, a UV light, and 2 12" x 8" pieces of mesh fabric. The ties that I use come in a variety of colors to suit your fabric color used - https://a.co/d/7HtPNCF

I achieve the multi color finish by using an AMS unit with the Bambulabs P1P

I use a magnetic PFLAT sheet available for sale on my website - https://kaizen3dprints.com/collections/p-flat-plates

The tie used is 3.1" at the bottom, and 19.5" from the bottom of the knot to the bottom of the tie. You may be able to able to resize the proportions of this match an existing tie you may have. If you use a normal tie, you'll have to apply the tie cover, after you've tied the tie (this method is more difficult).

Insert a pause command before layer 2 starts, place your mesh fabric down along with magnets to hold it tensioned, and resume the print. The print is .72mm tall, 3 layers at .24mm layer height. Once both prints are completed (minimum of 256x256mm build size required) trim away fabric as shown. Attach the two panels together with the UV curable resin where the fabric overlaps (see included PDF guide for tips). Install the snap fasteners, the male snap goes onto the tie, and the female snap goes onto the printed tie cover. The snap fasteners will line up with the holes. You will need a total of 10 pair of fasteners, per tie.