Hextraction Ball-Catcher & Mount

! v1. of the ball-catcher combo is ONLY compatible with the fancy board variant of Hextraction which uses gutters. A future version for the basic board may/may not be made !

Print Settings:

• No supports should be required
• Both have been printed successfully with a 0.28 layer height (0.2 may make the Hextraction logo at the front of the mount look nicer)

Fewer loose balls are just TWO prints away:

• x1 - HexBallCatcherMountV1 (Once printed, place the 2 extraction end-zones on top)
• x1 - HexGutterRampV1 (the two prongs should easily slide into the back of the mount)

Why use the mount?

• Like me, you're tired of balls going everywhere and want to play instead of chasing them
• You don't want the board to be as steep and want to flatten out the end-zones

Known Issues (future version may fix these issues):

_- The game board occasionally slides backward off the mount

• This model will not stand on its own until the balls or game board are placed on top_

To learn the original game: https://www.playhextraction.com/how-to-play

To support Hextraction's creator: https://www.patreon.com/zackfreedman