Paper Towel Holder

This part is the main paper towel holder designed for use with almost any paper towel roll.

You need to print:

• (2x) Paper Towel Holder v.2 (5).stl This is the main "arm" for the holder
• (2x) Paper Towel Holder v.2 (4).stl These are the inserts for the two endcaps for the dowel
• (2x) Paper Towel Holder v.2 (3).stl These are the endcaps that are press fit onto the wooden dowel to prevent it from falling off
• (2x) Paper Towel Holder v.2 (2).stl This is the holder that is fastened to the main arm with #8-32 x 3/4" machine screws with their respective nuts on the other side. This prevents the paper towel roll from flying off when you rip a piece off with one hand.

You screw two screws into the wall through the back of the main model, and you secure a 1" wooden dowel between the two arms. The two arms and the dowel can be as big as you want, to accommodate any paper towel roll. Then you attach the two dowel holders ("Paper Towel Holder v.2 (2).stl") to the main arms with the machine screws and nuts. Then you press fit the two end caps (with super glued inserts on the ends) to the wooden dowel. Done! Now you just lift the two dowel holders, take the dowel off (put the paper towel on the dowel), and put the dowel back on the arms, locking it into place with the retaining pieces.