Just a case to carry my soldering iron, electric screwdriver, some hex bits and some tips for the iron that also works as a stand for the soldering iron.

Anything with the following dimensions will be able to fix in the screwdriver slot:

Diameter: 16mm Length: Below 185mm

The bit holder allows for 16x 4mm hex bits.

It uses 1x608 bearing to hold the soldering iron, 6x M3*28mm screws and 6x M3 nuts.

It was printed with my Anycubic Kobra 2 Neo, at 0.2 layer height, at 40% rectilinear infill in PLA. In case the measurements of the case seem off I suggest going to the original author and downloading the model from there and separating the case, I used my slicer in order to separate it.