tracking pixel
Scott M

Closed Lattice Christmas Bell

by

dazus k

Follow
Follow
Remix Model
Like
dazus k
dazus k
Image 1 of 4
Closed Lattice Christmas Bell 3d model
2D
3D
Makes
Closed Lattice Christmas Bell 3d model
Closed Lattice Christmas Bell 3d model
Closed Lattice Christmas Bell 3d model
Closed Lattice Christmas Bell 3d model
This model is restricted by licensing terms. 
19 Likes49 DownloadsDecember 20, 2022
This model is restricted by licensing terms. 


This is the third in my 2022 Christmas bell series. It prints quickly and easily. Use a nice medium toned silky, metallic or multicolored filament to show off the geometry - or use translucent filament to make it glow.

This is based on my spiral and open lattice bells. It's roughly the same size (slightly taller) with a new loop at the top and a new lattice pattern.

Not for commercial use. Please see license agreement.

*** PRINT SETTINGS***

  • Walls: 0.4 - 0.8 mm (I used 0.4 mm for the clear bell and added an alternating extra line for the opaque bell)
  • Layer Thickness: 0.15 mm recommended. Anything from 0.1 - 0.2 mm should look good.
  • Infill: None. Seriously. It doesn't need it. It just adds weight and print time.
  • Rafts/Brim: I didn't use either. However, the first layer is just a single width circle, so you may need to add a brim or raft.
  • Supports: None. I designed this to print cleanly without them.

19 Likes49 DownloadsDecember 20, 2022





This model is restricted by licensing terms. 
19 Likes49 DownloadsDecember 20, 2022
This model is restricted by licensing terms.